Filter
Top Products
2–Pump 20-Station Controllers Installation 21 of 51
value. The keypad disappears, and the “Station Copy” screen shows the station
number you entered under Last Station.
5. Touch the green Copy to Range of Stations button. Complete briefly appears
on the screen.
6. As appropriate, either continue copying to other stations, or touch Return to go back
to the “Station Setup” screen.
Copying to All Other Stations:
1. On the “Station Copy” screen (Figure 9), touch the green Copy to All Stations
button. Complete briefly appears on the screen.
2. Touch Return to go back to the “Station Setup” screen.
Setting Up Pumps
Before starting the system, you must define several settings for each pump, such as how
quickly to shut it down when it is not in use. This section first discusses how to use the
controller’s menu system to configure pumps. The table on page 422 discusses the individual
choices.
Setting Up a Single Pump
1. Go to the “Pump Status“ screen if needed. To reach this screen from any other screen,
touch Menu on the right-hand side of the screen, and then touch Pumps. The “Pump
Status” screen appears:
Figure 10: “Pump Status” Screen
Stations
19-20
Stations
19-20
2. Touch the icon for the pump you want to set up, and hold it for several seconds. The
“Pump Setup” screen opens.