Filter
Top Products
MC-12 Basic Operation
2-13
COMMAND BANK ACTIVATION
Remote control buttons perform different commands depending on
whether the Main Zone, Zone 2, Record Zone, or Shift command
bank is activated. Pressing and releasing a remote control command
bank selection button – MAIN, ZONE, REC, or SHIFT – activates the
corresponding command bank. The selected command bank
remains activated until another command bank is activated.
The command bank selection buttons themselves do not send
commands to the MC-12. When pressed and released, these
buttons activate the corresponding command bank. For example,
pressing and releasing the SHIFT button activates the Shift
command bank. When the Shift command bank is activated,
pressing and releasing the DVD-1 button turns off the DVD1 input
for the Main Zone.
To activate a command bank:
1. Press and release a command bank selection button to activate
the desired command bank.
The command matrix that begins on the next page indicates
the commands remote control buttons perform when each
command bank is activated.
2. Press a remote control button to send a command to the MC-12.
The MAIN MENUSETUPDISPLAYSON-SCREEN DISPLAY
menu REMOTE STATE parameter controls the remote control
command bank indicator that appears on the on-screen display.
When the REMOTE STATE parameter is set to ON, a command bank
indicator appears in the top-right corner of the on-screen display to
indicate the last command bank from which the MC-12 received a
command. A "Z" appears when the Zone 2 command bank is
active. An "R" appears when Record Zone command bank is active.
An "S" appears when the Shift command bank is active. No letter
appears when the Main Zone command bank is active. When the
REMOTE STATE parameter is set to OFF, no command bank
indicator appears on the on-screen display.
Note:
Remote control command bank selection buttons should not be pressed
and held.