Commander GP User Guide
Issue code: gpxu2
Menu 0 Parameters D-7
2. If the junction temperature continues to rise
(due to the output current) after the
PWM
switching frequency has been halved, and the
temperature reaches the maximum permissible
value, the Drive will trip. The display will
indicate trip code Oh1.
Motor parameters
0.42 Motor – number of poles
RW Txt P
2 ~ 32 4 poles
Enter the number of motor poles (not pole pairs).
(See Configuring the Drive for the motor in Chapter 2
Getting Started.)
0.43 Motor – power factor
RW Uni S P
0 ~ 1.000 0.92
When Autotune is used, the power factor of the
motor is measured by the Drive and stored in 0.43.
The value can be seen when 0.43 is accessed. The
value may be higher than the value stated on the
motor rating plate.
If Autotune is not used, enter the value in 0.43.
0.44 Motor – rated voltage
RW Uni
Commander GP
EUR
USA
0 ~ 400
0 ~ 480
400 (EUR)
460 (USA)
V
V
Commander GP LV
EUR
USA
0 ~ 240
0 ~ 240
220
220
V
V
Enter the value from the rating plate of the motor.
(See Configuring the Drive for the motor in Chapter 2
Getting Started.)
0.45 Motor – rated speed
RW Uni
0 ~ 6000 0
RPM
Enter the value from the rating plate of the motor.
(See Configuring the Drive for the motor in Chapter 3
Setting up the Drive.)
0.46 Motor – rated current
RW Uni
0 ~ FLC FLC A
FLC is the maximum permissible continuous output
current of the Drive up to 40°C ambient
temperature and 3kHz
PWM switching frequency.
Enter the value from the rating plate of the motor.
(See Configuring the Drive for the motor in Chapter 2
Getting Started.)
0.47 Motor – rated frequency
RW Uni
0 ~ 1000.0 50 (
EUR)
60 (
USA)
Hz
Enter the value from the rating plate of the motor.
(See Configuring the Drive for the motor in Chapter 2
Getting Started.)
Drive software build number
0.48 Drive software build number
RO Uni
0 ~ 99
Status information
0.49 Security status
RO Uni
0 ~ 1 1
0.49 normally indicates 1. This shows that access
to the advanced parameters is not possible.
0.50 Software version number
RO Uni P
1 .00~ 99.99
