Commander GP User Guide
Issue code: gpxu2
D-20 Menu 0 Parameters
Pr Macro 0 Macro 2 Macro 3 Macro 4
0.11 Pre-ramp reference Pre-ramp reference Pre-ramp reference Pre-ramp reference
0.12 Post-ramp reference Post-ramp reference Post-ramp reference Post-ramp reference
0.13 Motor active-current Motor active-current Motor active-current Motor active-current
0.14 Jog reference Jog reference Jog reference Jog reference
0.15 Ramp mode selector Ramp mode selector Ramp mode selector Ramp mode selector
0.16 Stop mode selector Stop mode selector Stop mode selector Stop mode selector
0.17 Torque mode selector Status relay invert Status relay invert Status relay invert
0.18 S-ramp enable S-ramp enable S-ramp enable S-ramp enable
0.19 S-ramp da/dt limit S-ramp da/dt limit S-ramp da/dt limit S-ramp da/dt limit
0.20 Skip frequency 1 Skip frequency 1 Skip frequency 1 Skip frequency 1
0.21 Skip band 1 Skip band 1 Skip band 1 Skip band 1
0.22 Skip frequency 2 Skip frequency 2 Skip frequency 2 Skip frequency 2
0.23 Skip band 2 Skip band 2 Skip band 2 Skip band 2
0.24 Analog input 1 mode
selector
Analog input 1 mode
selector
Analog input 1 mode
selector
Analog input 1 (torque
reference) mode selector
0.25 Analog input 2 mode
selector
Motorized pot. reset Preset reference 1 Analog input 1
(torque reference)
0.26 Motorized pot. output
indicator
Preset reference 2 Analog input 2 (frequency
reference) mode selector
0.27 EUR> Positive logic select
USA> Sequencing mode
selector
Motorized pot. zero-start
select
Preset reference 3 Analog input 2 (speed
reference)
0.28 EUR> Current-loop
proportional gain
USA> Frequency demand
Motorized pot. bipolar
select
Preset reference 4 Over-speed threshold
0.29 EUR> Current-loop
integral gain
USA> Terminal-29
destination selector
Motorized pot. rate
Analog input 1 scaling
0.30 FWD/REV key enable Motorized pot. output
scale factor
Analog input 2 scaling
