Commander GP User Guide
Issue code: gpxu2
3-24 Setting Up the Drive
Pr Function User
value
0.00 Configuration and saving
0.01 Minimum frequency
0.02 Maximum frequency
0.03 Acceleration rate
0.04 Deceleration rate
0.05 Reference selector (do not adjust)
0.06 Current limit
0.07 Voltage mode selector
0.08 Boost voltage
0.09 Dynamic V/f select
0.10 Estimated motor speed [M]
[M] indicates the parameter is for monitoring only
For descriptions of these parameters, see
Appendix D Menu 0 Parameters.
List of parameters specific to Macro 3
Pr Function User
value
0.31 Macro number [M]
0.32 Serial comms. mode
0.33 Drive rated current (FLC) [M]
0.34 User security code [M]
0.35 Keypad reference [M]
0.36 Serial comms. baud rate
0.37 Serial comms. address
0.38 Initial parameter displayed
0.39 Synchronize to a spinning motor
0.40 Autotune
0.41 PWM switching frequency selector
0.42 Motor – number of poles
0.43 Motor – power factor
0.44 Motor – rated voltage
0.45 Motor – rated speed
0.46 Motor – rated current
0.47 Motor – rated frequency
0.48 Drive software build number [M]
0.49 Security status [M]
0.50 Drive software version [M]
Pr Function User
value
0.11 Pre-ramp reference [M]
0.12 Post-ramp reference [M]
0.13 Motor active-current [M]
0.14 Jog reference (not used)
0.15 Ramp mode selector
0.16 Stop mode selector
0.17 Status relay invert
0.18 S-ramp enable
0.19 S-ramp da/dt
0.20 Skip frequency 1
0.21 Skip band 1
0.22 Skip frequency 2
0.23 Skip band 2
0.24 Analog input 1 mode selector
0.25 Preset reference 1
0.26 Preset reference 2
0.27 Preset reference 3
0.28 Preset reference 4
0.29 (Not used)
0.30 (Not used)
