Commander GP User Guide
Issue code: gpxu2
3-6 Setting Up the Drive
Pr Function User
value
0.00 Configuration and saving
0.01 Minimum frequency
0.02 Maximum frequency
0.03 Acceleration rate
0.04 Deceleration rate
0.05 Reference selector
0.06 Current limit
0.07 Voltage mode selector
0.08 Boost voltage
0.09 Dynamic V/f select
0.10 Estimated motor speed [M]
[M] indicates the parameter is for monitoring only
For descriptions of these parameters,
see Appendix D Menu 0 Parameters.
List of parameters specific to Macro 0
Pr Function User
value
0.31 Macro number [M]
0.32 Serial comms. mode
0.33 Drive rated current (FLC) [M]
0.34 User security code [M]
0.35 Keypad reference [M]
0.36 Serial comms. baud rate
0.37 Serial comms. address
0.38 Initial parameter displayed
0.39 Synchronize to a spinning motor
0.40 Autotune
0.41 PWM switching frequency selector
0.42 Motor – number of poles
0.43 Motor – power factor
0.44 Motor – rated voltage
0.45 Motor – rated speed
0.46 Motor – rated current
0.47 Motor – rated frequency
0.48 Drive software build number [M]
0.49 Security status [M]
0.50 Drive software version [M]
Pr Function User
value
0.11 Pre-ramp reference [M]
0.12 Post-ramp reference [M]
0.13 Motor active-current [M]
0.14 Jog reference
0.15 Ramp mode selector
0.16 Stop mode selector
0.17 Torque mode selector
0.18 S-ramp enable
0.19 S-ramp da/dt limit
0.20 Skip frequency 1
0.21 Skip band 1
0.22 Skip frequency 2
0.23 Skip band 2
0.24 Analog input 1 mode selector
0.25 Analog input 2 mode selector
0.26 Analog input 2 destination selector
0.27 EUR> Positive logic select
USA> Sequencing mode selector
0.28 EUR> Current-loop proportional gain
USA> Frequency demand
0.29 EUR> Current-loop integral gain
USA> Terminal-29
destination parameter
0.30 FWD/REV key enable
