Filter
Top Products
En
27
Utilities modes
Changing the sampler velocity mode’s
velocity curve setting
Use the procedure below to set the sampler velocity mode’s velocity
curve. You can choose one of four types of velocity curves.
! By default, curve 1 is set.
Launch utilities mode 1, then press one of the [1/2X (IN)],
[2X (OUT)], [PARAMETERc] or [PARAMETERd] buttons.
The currently set value is indicated by the lighting status of the
[1/2X (IN)], [2X (OUT)], [PARAMETERc] and [PARAMETERd] buttons.
Curve 1
MIDI
code
Strength which
performance pad is pressed
Min.
Max.
Curve 2
MIDI
code
Strength which
performance pad is pressed
Min.
Max.
Curve 3
MIDI
code
Strength which
performance pad is pressed
Min.
Max.
Curve 4
MIDI
code
Strength which
performance pad is pressed
Min.
Max.
Enabling the sampler velocity mode’s
after touch setting
When the sampler velocity mode is turned on for this unit’s performance
pads, the after touch setting can be turned on and off.
After touch setting disabled: The sampler volume changes according
to the strength with which the performance pad is initially pressed, but
does not keep changing while the pad is held after it is initially pressed.
After touch setting enabled: The sampler volume changes according to
the strength with which the performance pad is initially pressed and the
strength with which the pad is held after it is initially pressed.
! By default, the after touch setting is disabled.
Launch utilities mode 1, then press the left deck’s
[SAMPLER] mode button.
! [SAMPLER] mode button lit: After touch setting enabled
! [SAMPLER] mode button off: After touch setting disabled
Adjusting the jog dial’s MIDI message
sending interval
This unit is equipped with a mode for adjusting the jog dial’s MIDI mes-
sage sending interval.
Depending on your computer’s operating system and specifications, the
jog dial may not operate properly if the sending interval of MIDI mes-
sage for JOG dial is too short. In this case, follow the procedure below to
adjust the MIDI message sending interval.
! From a short MIDI sending interval, increase the interval to a length
at which no problems occur.
! The default is 3 ms.
Launch utilities mode 1, then press the left deck’s [SHIFT]
button.
The MIDI message sending interval setting changes each time the but-
ton is pressed. The currently set value is indicated by how the master
level indicator is lit.
3 ms 4 ms 5 ms 6 ms 7 ms 8 ms
9 ms 10 ms 11 ms 12 ms 13 ms
Launching utilities mode 2
If the utilities mode is launched while the DJ application is running,
the set status may not be displayed properly.
1 Quit the DJ application on the computer.
2 Slide the [ON/OFF] switch on this unit’s rear panel to
the [OFF] side to turn this unit’s power off.
Turn off the power of this unit.
3 While simultaneously pressing the right deck’s [SHIFT]
and [PLAY/PAUSE f] buttons, slide the [ON/OFF]
switch on this unit’s rear panel to the [ON] side.
Utilities mode 2 is launched.
4 After setting utilities mode 2, operate the controller
for the items whose settings you want to change.
See the explanations below for the settings that can be changed.
5 Slide the [ON/OFF] switch on this unit’s rear panel to
the [OFF] side to save the settings.
To save the settings, slide the [ON/OFF] switch on this unit’s rear panel
to the [OFF] side to quit utilities mode 2.