Filter
Top Products
En
16
Playing tracks and outputting the sound
The following describes the procedure for outputting the channel 1
sound as an example.
! Set the volume of the devices (power amplifier, powered speakers,
etc.) connected to the [MASTER OUT 1] and [BOOTH OUT/MASTER
OUT 2] terminals to an appropriate level. Note that loud sound will
be output if the volume is set too high.
Mixer section
9
a
c
4
7
8
6
5
b
Front panel
d
f
e
Rear panel
g
h
4 TRIM control
5 EQ (HI, MID, LOW) controls
6 FILTER control
7 Headphones CUE/TAP button
8 Channel fader
9 MASTER LEVEL control
a HEADPHONES MIX control
b Level indicator switch
c Crossfader
d HEADPHONES LEVEL control
e CROSS FADER REVERSE switch
f CROSS FADER CURVE control
g BOOTH LEVEL control
h BOOTH/MASTER selector switch
1 Set the positions of the controls, etc., as shown
below.
Names of controls, etc. Position
MASTER LEVEL control Turned fully counterclockwise
TRIM control Turned fully counterclockwise
EQ (HI, MID, LOW) controls Center
FILTER control Center
Level indicator switch [CH1/2] position
Channel fader Moved forward
CROSS FADER REVERSE switch [OFF] position
BOOTH/MASTER selector switch [MASTER] position
BOOTH LEVEL control Turned fully counterclockwise
2 Press the [f] button to play the track.
3 Move the channel fader away from you.
4 Turn the [TRIM] control.
Adjust [TRIM] so that the orange indicator on the channel level indicator
lights at the peak level.
5 Turn the [MASTER LEVEL] control to adjust the audio
level of the speakers.
Adjust the sound level output from the [MASTER OUT 1] and [BOOTH
OUT/MASTER OUT 2] terminals to an appropriate level.
! When the [BOOTH/MASTER] selector switch is set to the
[BOOTH] position, the [BOOTH LEVEL] control can be used
to adjust only the audio level output from the [BOOTH OUT/
MASTER OUT 2] terminal to an appropriate volume.