Filter
Top Products
System Settings
164
ReadyNAS OS 6.0
4. On the General tab, configure the settings as explained in the following table:
Item Description
Name Cannot be edited. Displays the name of the
Ethernet interface.
Bandwidth Cannot be edited. Displays the bandwidth of the
Ethernet interface.
MTU Enter the MTU in bytes. The default setting is 1500 bytes.
VLAN ID Enter a VLAN ID. The default setting ID is 0.
5. Click the TCP/IP tab.
6. Configure the TCP/IP settings as explained in the following table:
Note: NETGEAR recommends that you use DHCP address reservation to
make sure
that the DHCP server always assigns the same IP address to the
interfaces of the ReadyNAS. The MAC addresses of the physical interfaces are
shown on the Network screen.
Note: If you use VLAN IDs, the switch to which you connect the ReadyNAS system
needs to support VLAN tagging.