Filter
Top Products
Easy I/O for DAQ Library Chapter 10
LabWindows/CVI Standard Libraries 10-66 © National Instruments Corporation
Table 10-5. Easy I/O for DAQ Error Codes (Continued)
-10848
noDMACountAvailErr The driver could not obtain a valid reading from the
transfer-count register in the DMA controller.
-10849
openFileErr Unable to open a file.
-10850
closeFileErr Unable to close a file.
-10851
fileSeekErr Unable to seek within a file.
-10852
readFileErr Unable to read from a file.
-10853
writeFileErr Unable to write to a file.
-10854
miscFileErr An error occurred accessing a file.
-10880
updateRateChangeErr A change to the update rate is not possible at this time
because: 1) When waveform generation is in progress, you cannot change the interval
timebase. 2) When you make several changes in a row, you must wait long enough
for each change to take effect before you request further changes.
-10920
gpctrDataLossErr One or more data points may have been lost during buffered
GPCTR operations due to speed limitations of your system.