Filter
Top Products
Chapter 10 Easy I/O for DAQ Library
© National Instruments Corporation 10-63 LabWindows/CVI Standard Libraries
Table 10-5. Easy I/O for DAQ Error Codes (Continued)
-10614
badGroupDirErr The specified group does not support the specified transfer
direction.
-10615
masterClkErr The clock configuration for the clock master is invalid.
-10616
slaveClkErr The clock configuration for the clock slave is invalid.
-10617
noClkSrcErr No source signal has been assigned to the clock resource.
-10618
badClkSrcErr The specified source signal cannot be assigned to the clock resource.
-10619
multClkSrcErr A source signal has already been assigned to the clock resource.
-10620
noTrigErr No trigger signal has been assigned to the trigger resource.
-10621
badTrigErr The specified trigger signal cannot be assigned to the trigger resource.
-10622
preTrigErr The pretrigger mode is not supported or is not available in the current
configuration, or no pretrigger source has been assigned.
-10623
postTrigErr No posttrigger source has been assigned.
-10624
delayTrigErr The delayed trigger mode is not supported or is not available in the
current configuration, or no delay source has been assigned.
-10625
masterTrigErr The trigger configuration for the trigger master is invalid.
-10626
slaveTrigErr The trigger configuration for the trigger slave is invalid.
-10627
noTrigDrvErr No signal has been assigned to the trigger resource.
-10628
multTrigDrvErr A signal has already been assigned to the trigger resource.
-10629
invalidOpModeErr The specified operating mode is invalid, or the resources have
not been configured for the specified operating mode.
-10630
invalidReadErr An attempt was made to read 0 bytes from the transfer buffer, or an
attempt was made to read past the end of the transfer buffer.
-10631
noInfiniteModeErr Continuous input or output transfers are invalid in the current
operating mode.
-10632
someInputsIgnoredErr Certain inputs were ignored because they are not relevant in
the current operating mode.
-10633
invalidRegenModeErr This device does not support the specified analog output
regeneration mode.
-10680
badChanGainErr All channels must have an identical setting for this device.
-10681
badChanRangeErr All channels of this device must have the same range.
-10682
badChanPolarityErr All channels of this device must have the same polarity.
-10683
badChanCouplingErr All channels of this device must have the same coupling.
(continues)