Filter
Top Products
Easy I/O for DAQ Library Chapter 10
LabWindows/CVI Standard Libraries 10-58 © National Instruments Corporation
Table 10-5. Easy I/O for DAQ Error Codes (Continued)
-10019
badClkFrequencyErr The frequency parameter is invalid.
-10020
badTimebaseErr The timebase parameter is invalid.
-10021
badLimitsErr The limits are beyond the range of the device.
-10022
badWriteCountErr Your data array contains an incomplete update, or you are
trying to write past the end of the internal buffer, or your output operation is
continuous and the length of your array is not a multiple of one half of the internal
buffer size.
-10023
badWriteModeErr The write mode is out of range or is invalid.
-10024
badWriteOffsetErr The write offset plus the write mark is greater than the internal
buffer size or it must be set to 0.
-10025
limitsOutOfRangeErr The voltage limits are out of range for this device in the
current configuration. Alternate limits were selected.
-10026
badInputBufferSpecification The input buffer specification is invalid. This error
results if, for example, you try to configure a multiple-buffer acquisition for a device
that cannot perform multiple-buffer acquisition.
-10027
badDAQEventErr For DAQEvents 0 and 1, general value A must be greater than 0
and less than the internal buffer size. If DMA is used for DAQEvent 1, general value
A must divide the internal buffer size evenly, with no remainder. If the TIO-10 is
used for DAQEvent 4, general value A must be 1 or 2.
-10028
badFilterCutoffErr The cutoff frequency is not valid for this device.
-10080
badGainErr The gain parameter is invalid.
-10081
badPretrigCountErr The pretrigger sample count is invalid.
-10082
badPosttrigCountErr The posttrigger sample count is invalid.
-10083
badTrigModeErr The trigger mode is invalid.
-10084
badTrigCountErr The trigger count is invalid.
-10085
badTrigRangeErr The trigger range or trigger hysteresis window is invalid.
-10086
badExtRefErr The external reference value is invalid.
-10087
badTrigTypeErr The trigger type parameter is invalid.
-10088
badTrigLevelErr The trigger level parameter is invalid.
-10089
badTotalCountErr The total count specified is inconsistent with the buffer
configuration and pretrigger scan count or with the device type.
-10090
badRPGErr The individual range, polarity, and gain settings are valid but the
combination specified is invalid for this device.
(continues)