Filter
Top Products
Easy I/O for DAQ Library Chapter 10
LabWindows/CVI Standard Libraries 10-64 © National Instruments Corporation
Table 10-5. Easy I/O for DAQ Error Codes (Continued)
-10684
badChanInputModeErr All channels of this device must have the same input
range.
-10685
clkExceedsBrdsMaxConvRate The clock rate selected exceeds the recommended
maximum rate for this device.
-10686
scanListInvalidErr A configuration change has invalidated the scan list.
-10687
bufferInvalidErr A configuration change has invalidated the allocated buffer.
-10688
noTrigEnabledErr The total number of scans and pretrigger scans implies that a
trigger start is intended, but no trigger is enabled.
-10689
digitalTrigBErr Digital trigger B is illegal for the total scans and pretrigger scans
specified.
-10690
digitalTrigAandBErr With this device, you cannot enable digital triggers A and B
at the same time.
-10691
extConvRestrictionErr With this device, you cannot use an external sample clock
with an external scan clock, start trigger, or stop trigger.
-10692
chanClockDisabledErr Cannot start the acquisition because the channel clock is
disabled.
-10693
extScanClockErr Cannot use an external scan clock when performing a single scan
of a single channel.
-10694
unsafeSamplingFreqErr The sampling frequency exceeds the safe maximum rate
for the ADC, gains, and filters you are using.
-10695
DMAnotAllowedErr You must use interrupts. DMA does not work.
-10696
multiRateModeErr Multi-rate scanning can not be used with AMUX-64, SCXI, or
pre-triggered acquisitions.
-10697
rateNotSupportedErr NI-DAQ was unable to convert your timebase/interval pair to
match the actual hardware capabilities of the specified board.
-10698
timebaseConflictErr You cannot use this combination of scan and sample clock
timebases for the specified board.
-10699
polarityConflictErr You cannot use this combination of scan and sample clock
source polarities for this operation, for the specified board.
-10700
signalConflictErr You cannot use this combination of scan and convert clock signal
sources for this operation, for the specified board.
-10740
SCXITrackHoldErr A signal has already been assigned to the SCXI track-and-hold
trigger line, or a control call was inappropriate because the specified module is not
configured for one-channel operation.
(continues)