Filter
Top Products
3-17
GVRP
Configuring GVRP On a Switch
The show vlans command lists the dynamic (and static) VLANs in switch “B”
after it has learned and joined VLAN-100 and VLAN-200.
Figure 3-9. Example of Listing Showing Dynamic VLANs
Converting a Dynamic VLAN to a Static VLAN. If a port on the switch
has joined a dynamic VLAN, you can use the following command to convert
that dynamic VLAN to a static VLAN:
For example, to convert dynamic VLAN 333 (from the previous example) to a
static VLAN:
ProCurve(config)# static 333
When you convert a dynamic VLAN to a static VLAN, all ports on the switch
are assigned to the VLAN in Auto mode.
Syntax:
static < dynamic-vlan-id >
Converts the a dynamic VLAN to a static VLAN.
Switch “A”
GVRP enabled.
3 Static VLANs:
–DEFAULT_VLAN
–VLAN-100
–VLAN-200
Switch “B”
GVRP enabled.
1 Static VLANs:
– DEFAULT_VLAN
Port 1: Set to
“Learn” Mode
ProCurve (config)# show vlans
Status and Counters - VLAN Information
Maximum VLANs to support : 8
Primary VLAN : DEFAULT_VLAN
Management VLAN :
VLAN ID Name | Status
------- -------------------- + ----------
1 DEFAULT_VLAN | Port-based
100 GVRP_100 | Dynamic
200 GVRP_200 | Dynamic
300 GVRP_300 | Dynamic
400 GVRP_400 | Dynamic
500 GVRP_500 | Dynamic
600 GVRP_600 | Dynamic
Dynamic VLANs
Learned from
Switch “A”
through Port 1