Filter
Top Products
3-16
GVRP
Configuring GVRP On a Switch
For example, to change and view the configuration for ports A1-A2 to Block:
Figure 3-8. Displaying the Static and Dynamic VLANs Active on the Switch
For example, in the following illustration, switch “B” has one static VLAN (the
default VLAN), with GVRP enabled and port 1 configured to Learn for
Unknown VLANs. Switch “A” has GVRP enabled and has three static VLANs:
the default VLAN, VLAN-222, and VLAN-333. In this scenario, switch B will
dynamically join VLAN-222 and VLAN-333:
Syntax: interface < port-list > unknown-vlans < learn | block | disable >
Changes the Unknown VLAN field setting for the specified
port(s).
Syntax:
show vlans
The show vlans command lists all VLANs present in the switch.
ProCurve (config)# interface d1-d2 unknown-vlans block
ProCurve (config)# show gvrp
GVRP support
Maximum VLANs to support [8] : 8
Primary VLAN : DEFAULT_VLAN
GVRP Enabled [No] : Yes
Port Type | Unknown VLAN
---- --------- + ------------
D1 1000X | Block
D2 1000X | Block
. . | .
. . | .
. . | .
X2 | Learn
C1 10GbE-CX4 | Learn