Filter
Top Products
4. Input & Communication
• HDMI (High-Definition Multimedia Interface)
HDMI 1.4a up to 210MHz pixel clock. Support for ‘Deep Color’ up to 12 bit per color.
• DisplayPort
DisplayPort 1.1a up to 210 MHz pixel clock. Support for ‘Deep Color’ up to 12 bit per color.
In all cases, the minimum input frequency for 3D is 23 Hz per eye. Below this frequency the image will not be
displayed correctly.
4.3 Communication connections
Communication interface
12V
/1A
IN
DMX
OUT
REMOTE CTRL
RS232/422 IN
USB
10/100 BASE-T
ETH
ACT
PWR LMP
10/100
ERR
IR ACT
WIFI
SEL
1
2
3
1 2 3 4 5 6 7 8 9 10 11 12 13 14
15
Image 4-5
Communication interface, indications
1 12V 1A output
2
DMX interface (input, output)
3 XLR input
4
RS232 input
5
USB port
6 Ethernet port
7
Ethernet type indication
8 Ethernet activity indication
9 Error indication
10 Power indication
11 IR indication
12 Lamp indication
13
ACT (activity) indication
14
Wifi select indication
15 IR receiver
12V output
12 V output, maximum 1A, available when projector is not in stand by.
DMX interface
DMX is used as communication bu
s between different devices in the light technic. Each device has an input and an output, so that
the bus can be looped between the different devices. According the standard a five wire cable with XLR connector is used.
You can use the DMX input port to connect a DMX device (DMX console) to the projector. This way you can control the projector
from that DMX device (console). The DMX output port can be connected with the next device in the loop.
Pin Description
1Earth
50
R5905032 HDX SERIES 05/12/2014