Filter
Top Products
2. General
Image 2-2
Remove carton and foam rubber
3. Take out the foam rubber.
4. Take out the projector.
Save the original shipping carton and packing material, they will be necessary if you ever have to ship your
projector. For maximum protection, repack your projector as it was originally packed at the factory.
A rubber foam inside a plastic bag is placed into the lens opening of the projector. It’s recommended to reuse
this foam and plastic back each time you transport the projector. This to prevent intrusion of dust and foreign
particles.
The lens is delivered in a separate box.
2.3 Initial inspection
General
Before shipment, the projector was inspected and found to be free of mechanical and electrical defects. As soon as the projector is
unpacked, inspect for any damage that may have occurred in transit. Save all packing material until the inspection is completed. If
damage is found, file claim with carrier immediately. The Barco Sales and Service office should be notified as soon as possible.
The packaging of the HDX projector is provided with a shock-watch label. If this shock-watch label was trig-
gered (red colored at arrival) during transport, that indicates that the package was possibly roughly handled
by the transport company. In this case, the instructions mentioned on the label, should be followed, which
are: adding anote on the “bill of lading”and informing the transportcompany andthe Barco salesand service
office as soon as possible.
Box content
After unpacking the projector it is recommended to check if all following items where included:
• Three power cords of 2.5 meter, one CEE (7), one NEMA L6-20P and one CH2–16P
• This manual (installation manual).
• One Safety manual
• One remote control unit (RCU)
• Two AA size batteries for the RCU.
R5905032 HDX SERIES 05/12/2014
15