Filter
Top Products
57
DP30 050940
Default
Calibration #
15.00 g/rev
P050940
# of Holes
Diameter
Disc Thickness
0.2 Rev./min
6.4Rev./min
(6.4 RPM)
0.5 Rev./min
11.5 Rev./min
(11.5 RPM)
1.0 Rev./min
35.5 Rev./min
(35.5 RPM)
15.64 g/Rev.
0.39 g/Hole
0.41 lb/hr
0.187 kg/hr
1.00 lb/hr
0.45 kg/hr
2.00 lb/hr
0.94 kg/hr
13.20 lb/hr
6.00 kg/hr
22.62 lb/hr
10.62 kg/hr
73.40 lb/hr
33.30 kg/hr
19.53 g/Rev.
0.49 g/Hole
0.51 lb/hr
0.23 kg/h
0.12 lb/hr
0.57 kg/hr
2.60 lb/hr
1.17 kg/hr
16.50 lb/hr
7.50 kg/h
28.65 lb/hr
13.80 kg/hr
91.70 lb/hr
41.60 kg/hr
DP30 250940
Default
Calibration #
7.80 g/rev
P250940
# of Holes
Diameter
Disc Thickness
0.2 Rev./min
6.4Rev./min
(6.4 RPM)
0.5 Rev./min
11.5 Rev./min
(11.5 RPM)
1.0 Rev./min
35.5 Rev./min
(35.5 RPM)
7.82 g/Rev.
0.20 g/Hole
0.20 lb/hr
0.093 kg/hr
0.46 lb/hr
0.21 kg/hr
1.00 lb/hr
0.47 kg/hr
13.2 lb/hr
3.00 kg/hr
10.55 lb/hr
4.78 kg/hr
36.70 lb/hr
16.65 kg/hr
9.76 g/Rev.
0.245 g/Hole
0.26 b/hr
0.115 kg/h
0.60 lb/hr
0.27 kg/hr
1.30 lb/hr
0.58 kg/hr
8.25 lb/hr
3.75 kg/h
13.57 lb/hr
6.15 kg/hr
45.85 lb/hr
20.80 kg/hr
Note 1: This guide is to be used for general disc selection for Digital Dosing unit applications. All rates shown are continuous throughput and are
based on free-flowing materials. Consult factory for regrind, powder and all hard to flow materials.
Note 2: Maximum feeder disc revolutions in one screw recovery period (injection mode) is 9.5 revolutions. Use proper disc sizing for injection mode
applications to ensure proper dispense of material during the recovery cycle. Maximum dispense during a recovery cycle should not exceed 9.5
revolutions of the metering disc.