Pioneer DDJ-RB Musical Toy Instrument User Manual


  Open as PDF
of 22
 
En
9
Connections and part names
Connections
Before connecting to the device or changing the connection, disconnect the USB cable. Only use the USB cable included with this unit.
Refer to the operating instructions for the component to be connected.
Power is supplied by the USB bus power. You can use the unit with only connecting to your computer.
Connect the connecting cable correctly after checking the place of the terminal on this unit.
! Connect the unit and your computer directly using the included USB cable.
! A USB hub cannot be used.
! Connect your computer connected with this unit to an AC power supply.
! This unit may not be used with the USB bus power in the following situation.
— Power supply capacity of the USB terminal on your computer is too low.
— Your computer is connected with other devices.
— Impedanceoftheheadphonesislowerthan32Ω.
— The [PHONES] output terminal is connected with a monaural jack.
Connecting output terminals
Rear panel
Speakers with a built-in
amplifier, powered
speakers, etc.*
1,
*
2
Microphone*
3,
*
4
*
1
An audio cable (RCA) is not included with this unit.
*
2
Turn the volume of the device(s) (speakers with a built-in amplifier, powered
speaker, etc.) connected to the [MASTER] output terminals to an appropriate
level. Note that the output sound may be loud if the volume is set too high.
*
3
Only unbalanced input is supported.
*
4
When not using a microphone, turn the [MIC LEVEL] control to the minimum
level.
Front panel
Headphones
Connecttheheadphoneswhichimpedanceis32Ωormore.Itisnotsupportedwith
thatimpedanceoftheheadphonesislowerthan32Ω.
Connecting your computer to the unit
1 Connect your computer to the unit via a USB cable.
Connect your computer to the unit via a USB cable.
USB cable (supplied)
Computer
2 Turn on your computer.
3 Turn on the device(s) (speakers with a built-in amplifier,
powered speakers, etc.) connected to the output terminal.
 previous next