Filter
Top Products
8 - 9 8 - 9
MELSOFT
8. PARAMETER SETTING
8.2 Servo Parameters
PURPOSE
Set the servo parameters transferred from the AD75M to the servo amplifiers over
the SSCNET (Servo System Controller NETwork).
There are the following three servo parameter types.
• Servo basic parameters
• Servo adjustment parameters
• Servo extension parameters
Set each servo parameter type in the Servo parameter edit dialog box.
Perform the following operation until the Servo parameter edit dialog box appears.
For the setting data, refer to the installation guide or instruction manual of the
servo amplifier and servomotor used.
BASIC OPERATION
1. Choose Servo parameter.
Double-click.
Double-click.
2. Double-click any item in the column of the axis to be set on the servo parameter
main screen.
Double-click any item in this column to set the axis #2 servo parameters.
Double-click any item in this column Double-click any item in this column
to set the axis #1 servo parameters. to set the axis #3 servo parameters.
3. As the Servo parameter edit dialog box appears, click the corresponding tab to
display the setting screen.
4. Set the screen data on the display/setting screen shown in any of Sections 8.2.1
to 8.2.3.
5. To exit, click the "OK" button.