5
p/n GH 19502091
DESCRIPTION
Description of the sickle bar
This agricultural implement can only operate by means of a
cardan shaft applied to the pto of an agricultural tractor
equipped with lift and universal three-point hitch. Since it is
movable, the mowing machine can be easily mounted on
tractors with different gauges or on tracked vehicles (Fig.
1). The two-motion tooth-blade system used in mowing
machines, makes possible a scissors cut which leads to a
higt speed operation on a any crop. The original tooth-blade
motion guarantees a sharp and clean cut on any type of
grass, be it damp or flattened. It is thanks to the total
absence of soil which this mowing system does not raise,
sharp because the stems are not frayed. The sickle bar may
also be used with the cutting arm tilted for working on canals,
ditches and embankments (Fig. 2 and 3).
ATTENTION
The sickle bar is suitable only for the uses
indicated. Any other use different from that
described in these instructions could cause
damage to the machine and represent a serious
hazard for the user.
It is therefore advisable to strictly comply with the following
instructions in order to prevent faults which could jeopardize
the correct and long-lasting operation of the implement.
Compliance with the instructions in this handbook is also
important since the Manufacturer declines all and every
responsibility for damage to persons or property
caused by negligence and failure to comply with these
instructions.
The Manufacturer shall, however, remain at the customers’
disposal for immediate and thorough assistance together
with anything else that may be required in order to ensure
the correct operation and maximum efficiency of the
implement.
The Manufacturer reserves the right to make any
modifications and improvements to the implement as may
be considered opportune, without being obliged to
immediately inform the user.
Fig. 1
Fig. 3
Fig. 2