Filter
Top Products
19
p/n GH 19502091
OPERATING
Adjustment
• Remove safety hook (D, Fig. 25), required only for
transportation, and fit it back in the slot positioned above
the chassis. Reduce to the minimum length in order to hook
it in (E, Fig. 25) with the sickle bar to lower.
• Fit the sickle bar by adjusting the tractor tie-rods so that,
when the sickle bar attachment is fitted to the three points
on the tractor, the external tip of the cutting arm is
approximately 2 inches. foward with respect to the arm
base (Fig. 26).
• Using chain (F, Fig. 27), adjust the height of the sickle bar
attachment with respect to the tractor. Attach the
appropriate link to the special plate hole (G, Fig. 27).
Adjust the height of the mower on the basis of the height
shown in Figure 27.
Mark the link used so that the same postion may be used
each time the sickle bar is fitted to the tractor.
• Adjust inclination of the cutting arm teeth using tie rod (H,
Fig. 28).
Min. 1.2 inches
Max. 2.7 inches
• Adjust the cutting height (Fig. 29) by moving the mowing
bar on the holes of the inner mowing bar support (I), and,
turning the nut of the outer mowing bar support (J), bring it
level with the ground.
H
D
E
J
I
Fig. 26
Fig. 28
Fig. 29
Fig. 25
Fig. 27
19.6
inches
F
G