Filter
Top Products
15
p/n GH 19502091
REMOVING
Removing sickle bar
The sickle bar must be set-up on flat and compact ground,
supported by the relative supports (A and B, Fig. 17).
1. Raise sickle bar.
2. Put parking stand (A and B, Fig. 17) in the DOWN
position: install spring locking pin in order to secure
parking stand (C, Fig. 17).
3. Lower sickle bar to the ground.
CAUTION: Before you work around hitch:
• STOP engine.
• LOCK park brake.
• FIRMLY block mower on horizontal surface.
4. Unhook the PTO schaft (, Fig. 18) from the tractor and
put in on the special hook.
5. Remove quik-lock pin (D, Fig. 19) and pin (E, Fig. 19)
from center link (F, Fig. 19).
NOTE: Put quik-lock pins and pins back into brackets
on sickle bar for storage.
6. Remove draft links (J, Fig. 19) from draft link brackets (G,
Fig. 19) by removing quiklock pins (H, Fig. 19) and pins
(I, Fig. 19).
NOTE: Put quik-lock pins and pins back into brackets
on sickle bar for storage.
7. Drive tractor forward slowly.
Removing sickle bar with Quick Coupler
1. Raise sickle bar.
2. Put parking stand (A and B, Fig. 17) in the DOWN
position: install spring locking pin in order to secure
parking stand (C , Fig. 17).
3. Lower sickle bar to the ground.
4. Raise the two Quick Coupler levers (V, Fig. 15) to unloch
sickle bar (Quick Coupler Figure, page 14).
5. Lower Quick Coupler till further free the sickle bar.
B
A
C
H
D
E
I
F
J
G
Fig. 17
Fig. 18
Fig. 19