Filter
Top Products
SERVICE
30
p/n GH 19502091
To restore the correct tolerance:
• unscrew the blade guide (Fig. 52);
• remove one or more shims (Fig. 53);
• put the blade guide back in the same position.
IMPORTANT: When replacing the teeth or the tooth-
holding bar, carry out the check described above.
When required, put back the shims to avoid striping
or damage.
Storage
It is advisable to proceed in the following way at the end of
the season or if the machine is to remain inactive for a long
period of time:
• Treat the implement in compliance with the instructions
given in the chapter entitled: "Cleaning and oiling the
cutters".
• Carefully check for any damaged or worn parts and replace
these as necessary.
• Fully torque all screws and bolts.
• Apply a little lubricant to the unpainted parts.
• Protect the entire implement with a cover.
• Lastly, store the implement in a dry place where it cannot
be tampered with by unauthorized persons; the mowing
machine must be set-up on flat and compact ground,
supported by the relative supports (F and G, Fig. 54).
Careful compliance with these instructions will be all to
the advantage of the user who will be sure to use an
implement in perfect conditions when work begins again.
G
F
Fig. 54
Fig. 52
Fig. 53
D
E