Filter
Top Products
8
Folding up the Ready Chassis
When folding the CTS Ready Chassis up, the procedure is the
reverse of the above: First pull or release the auto-lock disk on
one side and push the short lower side tube slightly forwards.
Repeat this procedure on the other side. Push the short lower
side tube fully forwards.
WARNING
Do not attempt to fold up the passenger compartment without
disengaging the auto-lock disk.
TIP
The passenger compartment can only be completely folded
up if the rear storage bag is folded up (see Section 4.7),
except on the Cheetah, where the storage bag is fi xed in
position.
TIP
The passenger compartment can only be folded up if the hit-
charm is removed from the out-of-use storage position in the
Click ‘n’ Store bracket (located at the top of the short lower
side tube at the rear); see Sections 5 and 6.
WARNING
When folding up the CX the handlebar cannot be completely
removed because of the brake cable. You can pull it out of
the upper frame tube ends and then store it on the folded
carrier to save space.
4.3 Wheel assembly
The wheels of the Chariot models described are fi tted with
so-called push-button axles. Pressing on the rubber cap in the
wheel centre will loosen the retaining balls which lock the axle
in the axle socket. The wheels can only be fi tted and removed
with the plastic cap pushed in.
TIP
The easiest way to fi t the wheel is to lay the carrier on its
side.
TIP
On the CX, fi rst remove the plastic protective caps from the
brake drums. Keep the plastic caps safe, so that you can refi t
them when you next remove the wheels.
To fi t the wheel, press in the rubber cap and insert the wheel
axle into the axle socket until it can go no further. Release the
rubber cap. By moving the wheel from side to side, check that it
is locked in the axle socket and cannot be pulled off.
TIP
If the wheels on the CX cannot be inserted, this may be due
to the adjustment or the cables on the brake system. In this
case, please see Section 4.10.
DANGER
Always check that both wheels are properly seated by pulling
the wheel hard to one side without pressing the unlocking
button. To do this, lift the carrier, and make sure that the fi tted
wheel cannot be pulled off, by giving it a few good shakes on
each side.