Filter
Top Products
22
Wheel removal
TIP
When removing the wheels, the parking brake must be off.
Ensure too that all brake cables with their end caps are pro-
perly located in the relevant hole of the adjusting screws. If
necessary do the same for the adjusting screw on the brake
lever (the one that you are not to adjust).
To remove the wheel press the unlocking button in the centre of
the wheel and pull the wheel off to the side.
The brake mechanism that is now exposed is sensitive to dirt.
To protect it from dirt, Chariot supplies two protective caps. We
recommend that each time the wheels are removed these caps
be inserted on the brake callipers.
Fitting this cap is particularly important when you are using the
XC skiing kit.
Wheel fi tting
TIP
When fi tting the wheels, the parking brake must be off. Ensu-
re too that all brake cables with their end caps are properly
located in the relevant hole of the adjusting screws. If neces-
sary do the same for the adjusting screw on the brake lever
(the one that you are not to adjust).
DANGER
Make sure that you check that both wheels are properly
seated by pulling the wheel hard to one side without pres-
sing the unlocking button. To do this lift the carrier slightly
and hold it fi rm with one hand. Check a number of times that
the wheel cannot be pulled off, and give it a good shake as
well to make sure.
To fi t the wheel, press the unlocking button in the centre of the
wheel and push the axle into the wheel mount socket until it can
go no further. Release the unlocking button. The axle will now
click in.