A SERVICE OF

logo

Open as PDF
next previous
Registration assembly
1. Before proceeding, remove the following components:
●
Rear-door assembly. See
Rear-door assembly on page 62.
●
Left cover. See
Left cover on page 66.
2. Unhook the clasp on the registration assembly gear (callout 1), and then slide the gear off of the
shaft.
Figure 2-85 Remove the registration assembly (1 of 3)
1
3. Open the cartridge door, and then remove four screws (callout 1).
Figure 2-86 Remove the registration assembly (2 of 3)
1
102 Chapter 2 Removal and replacement ENWW