Toshiba 46TL900A Model Vehicle User Manual


 
CONTROLS AND FEATURES
26
Using 3D functions
Before using 3D programming, see and follow
“When using the 3D glasses” section on page 7.
Viewing 3D programming requires the following:
TOSHIBA 3D Glasses FPT-AG02G (not supplied)
Compatible 3D playback device or 3D source
3D capable high quality HDMI cable
Using the 3D glasses
Names and functions
To set the 3D glasses:
a
When you use for the
 rst time, peel o the
protective  lms from
the lenses.
Peel o
b
Turn the 3D glasses on
with the power switch.
NOTE: If the infrared data communication between
the television and 3D glasses is lost for 5 minutes,
the 3D glasses turn o automatically to preserve
battery life.
To charge the battery:
If the 3D glasses are turned on while the battery
power is low, the power light will blink 5 times. (If the
battery is dead, the power light will not blink or light.)
a
Turn the 3D glasses o with the power
switch, and connect to the TV with the
battery charge cable.
USB
NOTE:
If the 3D glasses are turned on, the battery
will not charge.
When the TV is turned o or in standby
mode, the battery will not charged.
When charging the battery the use of a
USB cable other than the battery charge
cable supplied is not covered by warranty.
b
The power light will Light up.
c
When the light goes out, the charging is
completed.
NOTE:
It takes approximately two hours to charge
the battery.
If the usage time is extremely short even
after the battery has been charged fully,
the battery may be worn out. Contact your
dealer.
To check the battery level:
When the 3D glasses are turned on, the behavior of
power light is di erent.
Charged: Lights up for 2 seconds
Low charge: Blinks 5 times
CAUTION: Danger of explosion if battery is
incorrectly disposed.
Lens (liquid-crystal
shutter)
A right and left liquid-
crystal shutter opens
and closes alternately
with the images for
the left eye and for the
right eye alternately
projected on the
television screen.
In this way, 3D images
are reproduced.
Power switch and
power light
Turns on or o the
power of 3D glasses
with the switch.
– When working,
the power light
blinks once every
2 seconds.
– When the power
is turned o , the
power light goes
out.
ON
OFF
Power switch
Power light
Infrared reception part
Receives the infrared
signal for the liquid-
crystal shutter control
sent from the television.
USB terminal
When charging the
battery, connect
to the TV with the
battery charge cable.
DC IN
Protective  lms
Peel these o before beginning use.