Filter
Top Products
Teledyne API Model 401 O
3
Photometric Calibrator Instruction Manual, 01124, Rev. J2
LIST OF TABLES
TABLE 1-1: TEST VALUES.......................................................................................................................1-21
T
ABLE 2-1: PASSWORD LEVELS ...............................................................................................................2-3
T
ABLE 2-2: SYSTEM MODES ....................................................................................................................2-5
T
ABLE 2-3: TEST MEASUREMENTS ..........................................................................................................2-6
T
ABLE 2-4: WARNING MESSAGES............................................................................................................2-7
T
ABLE 2-5: STATUS LEDS........................................................................................................................2-9
T
ABLE 3-1: CALIBRATION CONTROLS......................................................................................................3-3
T
ABLE 4-1: SETUP VARIABLES.................................................................................................................4-7
TABLE 5-1: TEST CHANNEL OUTPUT........................................................................................................5-2
T
ABLE 5-2: DIAGNOSTIC TESTS ...............................................................................................................5-2
T
ABLE 7-1: RS-232 MESSAGE TYPES ......................................................................................................7-1
T
ABLE 7-2: WARNING MESSAGE CLEAR COMMANDS..............................................................................7-4
T
ABLE 7-3: STATUS REPORTS ..................................................................................................................7-4
T
ABLE 7-4: CONTROL COMMANDS...........................................................................................................7-5
T
ABLE 7-5: DIAGNOSTIC COMMANDS ......................................................................................................7-6
T
ABLE 7-6: SPECIAL DIAGNOSTIC COMMANDS........................................................................................7-7
T
ABLE 7-7: DIAGNOSTIC REPORTS...........................................................................................................7-7
T
ABLE 7-8: TEST MEASUREMENT REQUEST COMMANDS.........................................................................7-8
T
ABLE 7-9: RS-232 VARIABLE NAMES..................................................................................................7-10
T
ABLE 8-1: THE CALIBRATOR HAS THE FOLLOWING STATUS CONDITIONS.............................................8-7
T
ABLE 9-1: WARNING MESSAGES............................................................................................................9-4
T
ABLE 9-2: TEST FUNCTION VALUES.......................................................................................................9-5
T
ABLE 9-2: TEST FUNCTION VALUES (CONTINUED) ................................................................................9-6
T
ABLE 9-3: V/F BOARD JUMPERS - FACTORY SETTINGS ........................................................................9-12
T
ABLE 9-4: V/F BOARD DIP SWITCHES - RANGES FOR ANALOG OUTPUT..............................................9-12
T
ABLE 9-5: UV SOURCE LAMP AND DETECTOR DIAGNOSTICS..............................................................9-15
T
ABLE 10-1: MAINTENANCE SCHEDULE ................................................................................................10-1
T
ABLE 11-1: SPARE PARTS FOR CE MARK UNITS..................................................................................11-1
T
ABLE 11-1: SPARE PARTS FOR CE MARK UNITS (CONTINUED)...........................................................11-2
T
ABLE 11-2: SPARE PARTS FOR NON-CE MARK UNITS.........................................................................11-3
T
ABLE 11-2: SPARE PARTS FOR NON-CE MARK UNITS (CONTINUED) ..................................................11-4
T
ABLE A-1: AVAILABLE MODEL 401 OPTIONS....................................................................................... A-1
T
ABLE E-1: ELECTRICAL SCHEMATIC INDEX ...........................................................................................E-1
viii