Filter
Top Products
7
Introduction
This manual is provided by Powermatic covering the safe operation and maintenance procedures for a
Model TS29 Tilting Spindle Shaper. This manual contains instructions on installation, safety precautions,
general operating procedures, maintenance instructions and parts breakdown. This machine has been
designed and constructed to provide years of trouble free operation if used in accordance with
instructions set forth in this manual. If there are any questions or comments, please contact either your
local supplier or Powermatic. Powermatic can also be reached at our web site: www.powermatic.com.
Specifications
Model Number ................................................................................................................................... TS29
Stock Number...............................................................................................................................1791284
Motor ............................................................................................ 7.5HP, 3Ph, 230/460V (Prewired 230V)
Electric controls ................................................................................................................ 24 volt magnetic
Interchangeable Spindle Sizes (with Capacity Under Nut) (in.) .................... 1-1/4 (6-1/2); 1 (6); 3/4 (3-1/2);
and 1/2 collet chuck with 1/4 bushing
Spindle Vertical Travel (in.) ...................................................................................................................... 7
Spindle Speeds (RPM) ....................................................................... 3000, 4000, 6000, 8000 and 10,000
Spindle Tilt (degrees).................................................................................................... 5 back, 45 forward
Overall Table Size (L x W) (in.) ........................................................................................... 51-1/2 x 33-1/2
Sliding Table Size (L x W) (in.) ............................................................................................ 51-1/4 x 11-1/4
Sliding Table Travel (in.) .................................................................................................................. 49-1/4
Maximum Diameter Cutter Below Table (in.) ............................................................................................ 9
Maximum Diameter Cutter Above Table (in.) .......................................................................................... 12
Table Inserts (in.)....................................................................three: 2-1/2 I.D.; 5-1/2 I.D.; and oval slotted
Fence Size (with Mechanical Digital Readouts) (in.) .......................................................................... 46 x 5
Fence Travel (Major and Minor) (in.) .................................................................................. 5-3/8 and 3-5/8
Dust Port Diameter (two) (in.) .................................................................................................................. 5
Dust Collection Minimum CFM Required .............................................................................................. 800
Shipping Weight (lbs.)........................................................................................................................ 1280
Net Weight (lbs.) ................................................................................................................................ 1100
Overall Dimensions (L x W x H) (in.) ....................................................................................... 51 x 44 x 53
The above specifications were current at the time this manual was published, but because of our policy of
continuous improvement, Powermatic reserves the right to change specifications at any time and without
prior notice, without incurring obligations.