Filter
Top Products
10
4. Thread the short threaded end of the draw
bar (B, Figure 3) into the threaded hole in
the bottom of the interchangeable spindle
(A, Figure 3). Remove the two lock nuts and
the bevel washer from the other end of the
draw bar (B, Figure 3).
5. Carefully insert the draw bar (B, Figure 3)
and spindle (A, Figure 3) down through the
shaft as shown. Make sure the tang (C,
Figure 3) on the spindle is engaged with the
notch (D, Figure 3), and thread the spindle
nut (E, Figure 3) onto the threads (F, Figure
3).
6. Engage spindle lock [refer to "Spindle Lock"
on page 15].
7. Use the supplied spanner wrench (G, Figure
4), to tighten the spindle nut (E, Figure 4).
8. Open the cabinet door and assemble the
bevel washer (H, Figure 5) to the bottom of
the draw bar (B, Figure 5).
9. Assemble and securely tighten the two lock
nuts (I, Figure 5) with a 19mm wrench.
10. Disengage the spindle lock.
Installing Cutters
1. Disconnect machine from power source and
engage spindle lock.
2. Place cutter (A, Figure 6) and desired
spindle collars (B, Figure 6) on the spindle
as shown.
3. Install keyed washer (C, Figure 6) and
tighten nut (D, Figure 6) using the supplied
wrench.
4. Disengage spindle lock before operating.
NOTE: Whenever possible, the cutter should be
positioned on the spindle in such a way that the
cut is being performed under the surface of the
workpiece.
Always place the keyed
washer (C, Figure 6) on the spindle before
threading the nut. Failure to comply may
cause serious injury.
Figure 3
Figure 4
Figure 5
Figure 6