Filter
Top Products
11
Fence Assembly
1. Place the fence body (A, Figure 7) on the
table. Mount the two fence locking handles
(E, Figure 7) with washers, and secure
fence to table using one of the two sets of
holes on the table.
2. Fasten bar (B, Figure 8) to the front of the
fence half using the locking lever (C, Figure
8) and washer. Slide an aluminum fence (D,
Figure 8) onto the bar. (NOTE: Right hand
and left hand fences are slightly different.
Only one washer is required under lever (C)
shown in Figure 8. Other side requires two
washers under the lever.)
3. Repeat for the other side.
NOTE: Locking levers (C, Figure 8) are spring
loaded and can be repositioned by pulling out
the handle and rotating it on the nut.
4. Mount the cover plate (K, Figure 7) using the
two locking knobs and flat washers.
Guard Assembly
The guard assembly can be mounted in various
configurations, depending upon the type of work
being done. Figure 7 shows one such
configuration.
1. Mount the spring guard (F, Figure 7), hold-
down (G, Figure 7) and clear plastic guard
(H, Figure 7) to mounting rod (J, Figure 7)
located on top of fence cover (K, Figure 7),
using rod and clamps. The latch on the
mounting rod (L, Figure 7) can be pushed
down to help secure the guards in place.
2. The spring guard (F, Figure 7), hold-down
(G, Figure 7) and clear plastic guard (H,
Figure 7) can be flipped up out of the way
when not in use or when making
adjustments. Simply pull up the latch (L,
Figure 7) and flip the entire assembly to the
back.
Dust Chute
Mount the dust chute to rear edge of table using
two M5 x 10 pan head screws and two M5 flat
washers. See Figure 9.
Figure 7
Figure 8
Figure 9