Filter
Top Products
30
206-4245
CHANNEL PREVIEW - BANK 1
CH 011-001 NORMAL-ADDED
Enter -> Change
CC -> VCHIP Menu, Ch. Preview -> Exit
Channel Banks Setup
Channel Banks Overview
Channel Banks enable institution administrators to create tiered channel programming on patient in-room
TVs. Each channel bank may offer a custom channel lineup for a pre-determined fee. 42LQ640H TVs are
configured with four channel banks, i.e., Channel Banks 1, 2, 3, and 4. The top tier generally contains the
most programming (premium, etc.), 2nd tier = lesser programming, 3rd tier = basic programming, etc. It is
also possible to create an Inactive TV display with Channel Bank 4, so that an “Inactive TV Call Attendant”
message appears when the TV is turned ON. In this case, an administrator can then select another
channel bank on the patient’s in-room TV depending on the programming tier requested by the patient.
All channels found during Auto Tuning automatically will be “ADDED” to all four channel banks, and the
default is for all channels to be active (NORMAL) in Channel Banks 1, 2, 3, and 4.
Note: Channel banks are not supported on TVs that are congured for FTG Mode operation.
Before You Begin
• Run the Express Script Installer Menu Wizard or complete the Custom Master TV Setup procedure (see
pages 10 to 14 or pages 25 to 28, respectively).
Note: Channel banks can be dened as part of the Express Script Installer Menu Wizard, if desired.
However, if you are setting up channel banks after completing the Express Script or if you are creating a
customized Master TV Setup, use the Channel Preview/Banks Setup Menu as described below.
• Installer Menu item 028 CH. OVERIDE must be set to 1 to allow access for channel banks setup.
Accessing the Channel Preview/Banks Setup Menu
1. To select a channel bank, press BANK on the Installer Remote. The rst time you press the BANK key,
the TV display will show the currently active channel bank. Press BANK repeatedly until the
desired channel bank is selected.
2. After the desired channel bank is selected, press CH PREVIEW on the Installer Remote to display the
Channel Preview/Banks Setup Menu (see below).
Typical Channel
Preview/Banks Setup
Menu
Note: In the Installer Menu, all available Aux inputs are enabled by default. The Aux inputs will appear between
the highest analog and lowest digital channel number in the channel lineup when Channel Up/Down is used
on the Installer Remote. If an Aux input will not be used, it is advisable to disable it. If using the Express
Script, customize the Aux inputs as appropriate in the Aux Input screen (step 2). If performing the Custom
Master TV Setup procedure, ensure Installer Menu items 035, 039, 087, 091, and 092 are set as required
before performing the 2-5-5 + MENU operation (step 5). After the TV setup is transferred to the PTC, the only
way to remove Aux inputs from the channel lineup is to go to the Channel Preview/Banks Setup Menu and
select NORMAL-DELETED.