Filter
Top Products
25
206-4245
Custom Master TV Setup
Clonable TV Setup Menu Features
Notes:
• Some menu options vary between analog and digital channels and Aux inputs.
• The end user only has access to features that are available on the pillow speaker or the
user remote control if provided by the institution.
Before You Begin
• It is recommended that you disconnect all Aux inputs if
you intend to run Auto Tuning (Channel Search). Under
certain conditions, Auto Tuning is disabled if there is an
Aux input active.
• If not disabled in the Installer Menu, Aux sources will
appear in the channel scan between analog and digital
channels after the TV setup is transferred to the
commercial controller (PTC).
• Determine which cloning tool—USB memory device or
clone programmer—is appropriate for your application;
several of the Master TV Setup procedure steps are
dependent on the cloning tool to be used. See “Cloning
Methods” at right for further information.
• If you intend to use a USB memory device, determine the
type of le—either the new “.tlx” le format or the legacy
“.tll” le format—to use for cloning purposes; several of
the Master TV Setup procedure steps are dependent on
the desired le type. See “Cloning Methods” at right for
further information.
• If the Express Script Installer Menu Wizard appears on
the screen, exit the Express Script before beginning/
continuing the Custom Master TV Setup procedure.
Cloning Methods
See also “Clonable TV Setup Menu Features” list below.
Using a USB Memory Device / .tlx File
• The .tlx le format clones Installer Menu settings and all
TV sources’ (analog, digital, AV1, HDMI, etc.) clonable
setup menu settings.
• Not intended for cloning an auto-tuned/edited Channel
Map, as the channel lineup is converted to a logical FTG
Channel Map when saved (Learned) from a TV to a .tlx
le. If the .tlx le with the FTG Channel Map is then used
for Teaching purposes, all Target TVs will be congured
for FTG Mode via CPU.
Using a USB Memory Device / .tll File
The .tll le format clones the contents of the commercial
controller (PTC) memory, including an auto-tuned/edited
Channel Map, Installer Menu settings, and one TV source’s
(analog, digital, or Aux) clonable setup menu settings.
Using a Clone Programmer (TLL-1100A or LT2002)
Both the TLL-1100A and LT2002 clone the contents of the
commercial controller (PTC) memory, including an auto-
tuned/edited Channel Map, Installer Menu settings, and one
TV source’s (analog or Aux) clonable setup menu settings.
This section describes how to create a customized Master TV Setup for cloning purposes when the TV is in
Pass-through Mode.
Note: Cloning requirements and procedures are described in detail on pages 34 to 42. Refer to FTG Mode
information on pages 43 to 49 for details on entering FTG Mode and conguring/editing the FTG Channel Map
and FTG Installer Menu settings.
Channel
Auto Tuning (Channel Lineup)
Manual Tuning
Channel Edit
Channel Label
Picture
Picture Mode *
Audio
Auto Volume
Clear Voice
Balance
Sound Mode
AV Sync. Adjust *
Time
Clock Mode (Auto/Manual) *
Time Zone
Auto Off
Option
Language
Caption
Standby Light
* Advanced Control (Picture Mode), AV Sync. Adjust, and DST (Clock Mode) settings are cloned via .tlx file only.