Filter
Top Products
ASSEMBLY
INSTRUCTIONS
FITNESS SYSTEMS
R
HOIST
2403 Assembly
Page 25
FRAME ASSEMBLY
Step 2k
In this step start by sliding one Aluminum Ring on both the right
and left handles. Then slide on one Rubber Grip on each side. Place an
Aluminum End Cap on the end of the handle. Once all three pieces (per
side) are in place, secure the End Caps, slide the Rubber Grip flush with
the End Cap, and slide the Aluminum Rings flush with the Rubber Grips
and secure. Same process for the back handle of the Seated Frame
Assembly. Next use a spray can of by
spraying an “X” pattern and also around the edges. Now attach the
Rubber Foot Pad to the Foot Rest Assembly as shown.
screws.
3M Contact 80 Neoprene Adhesive
Wrench tighten
23 - Aluminum Ring
51 - Aluminum End Cap
52 - Rubber Foot Pad
58 - Rubber Grip
63 - Rubber Grip
(10.50 LG.)
(8.25 LG.)
Part Descriptions
T - 10-32 x 1/8” Set Screw
Hardware Descriptions