Filter
Top Products
FRAME ASSEMBLY
In this step, attach the Linear Pillow Block Bearings to the Seated
Assembly. Before Sliding the Seated Assembly onto the Long Stand-Off Rail
and the Short Stand-Off Rail, make sure the rails are apply with grease. Now
attach (65) to (4). bolts including all previously hand tightened
bolts.
Wrench tighten
Step 2h
9 - 2” x 4” End Cap
11 - Seated Assembly
14 - Pull Pin
65 - 1/4” Stainless Steel Plate
(HH)
Part Descriptions
D - 10-24 x 3/4” Button Head Screw
X - 3/8”-16 x 1” Flat Head Screw
AE - 10mm Flat Washer
CC - Bumper Stopper
CD - Linear Pillow Block Bearing
CQ - 3/8” Inserts
(White Zinc)
(White Zinc)
Hardware Descriptions
Page - 19 2403 Assembly
FITNESS SYSTEMS
R
HOIST
ASSEMBLY
INSTRUCTIONS