Filter
Top Products
ASSEMBLY
INSTRUCTIONS
FITNESS SYSTEMS
R
HOIST
33 - Center RH (BRK) Assembly
34 - Add On Rods
35 - Add On Weights
36 - Weight Selector Pin
37 - Guide Rods
38 - Weight Bumpers
39 - Guide Rod Bushings
40 - 41 lbs. Steel Top Weight
41 - 20 lbs. Intermediate Weight
64 - Add On Weight Bushing
Part Descriptions
K - 3/8”-16 x 1” Button Head Screw
L - 5/16”-18 x 1” Button Head Screw
M - 3/8”-16 x 1” Button Head Screw
N - 3/8”-16 x 2 3/4” Flat Head Cap Screw
AG - 3/8” Lock Washer
AH - 3/8” Flat Washer
AJ - 3/8” Lock Washer
AK - 3/8” Flat Washer
AL - 5/16” Lock Washer
AM - 5/16 Flat Washer
AN - 3/8” Split Washer
CK - Selector Pin Lanyard
CM - Top Weight Roll Pin
CN - Guide Bearing
CP - Guide Bearing
(Black Zinc)
(Black Zinc)
(White Zinc)
(White Zinc)
(White Zinc)
(White Zinc)
(Black Zinc)
(Black Zinc)
(Black Zinc)
(Black Zinc)
(White Zinc)
(Tall)
(Short)
Hardware Descriptions
2403 Assembly
Page 15
FRAME ASSEMBLY
Step 2f
In this step start by pressing the two Guide Rod Bushings into the
Weight Cage. Take the two Weight Bumpers and place them over the two
holes in the bottom of the Weight Cage. Now slide the Guide Rods into
the holes. Make sure the Guide Rods are lube with Spindle Oil. Now,
slide (20) 20 LBS. Intermediate Weight Plates and the (1) 41 LBS. Steel
Top Plate onto the Guide Rods. Make sure the Weight Stack and its
Guide Rods are sitting level. Next attach the Add On Rod to the Center
RH (BRK) Assembly. Secure the Center RH (BRK) Assembly to the 41
LBS. SteelTop Plate, slide on the three Add On Weights and attach
another Add On Rod to the Weight Cage. Attach bigger end of the
Selector Pin Lanyard to the Center RH (BRK) Assembly, and the other
end to the Weight Selector Pin. Then bolts.Wrench tighten