Filter
Top Products
ASSEMBLY
INSTRUCTIONS
FRAME ASSEMBLY
Step 2i
In this step start by pressing two 1” O.D. X 3/4” I.D. Flanged Oilites
into the Seated Frame Assembly. Attach the Range Adjuster Plate to the
Back Adjuster Seated Assembly. Next insert the 3/4” x 4 27/32” Shaft
into the Seated Frame Assembly. Make sure the 1/8” hole on the Shaft is
in line with the 3/16” hole on the Seated Frame Assembly. Then insert
any small metal pin to secure the Shaft for bolt alignment. Now remove
the small metal pin when finish bolting.. Next attach the Back Adjuster
Seated Assembly to the Seated Frame Assembly as shown. For the final
step, attach the 0.125” x 1.50” x 1.79” Plate to the end of the Back
Adjuster Seated Assembly as shown. Then bolts
including all previously hand tightened bolts
Wrench tighten
.
FITNESS SYSTEMS
R
HOIST
14 - Pull Pin
17 - Back Adjuster Seated Assembly
18 - 0.125” x 1.50” x 1.79” Plate
19 - Range Adjuster Plate
20 - 3/4” x 4 27/32” Shaft
Part Descriptions
E - 3/8”-16 x 3/4” Flat Head Screw
F - 3/8”-16 x 1 1/2” Flat Head Screw
CE - 1” O.D. X 3/4” I.D. Flanged Oilite
(White Zinc)
(White Zinc)
U - 1/4”-20 x 3/4” Button Head Screw
AR - 1/4” Lock Washer (White Zinc)
AS - 1/4” Flat Washer (white Zinc)
(White Zinc)
Hardware Descriptions
2403 Assembly
Page 21