Filter
Top Products
Part No. 52421 Genie Z-45/25 & Genie Z-45/25J 29
Operator's ManualFirst Edition · Seventh Printing
Free-wheel Configuration for
Winching
Chock the wheels to prevent the machine from
rolling.
Release the non-steer wheel brakes by turning
over the drive hub disconnect caps (see below).
Be sure the winch line is properly secured to the
drive chassis tie points and the path is clear of all
obstructions.
Reverse the procedures described to re-engage the
brakes.
Note: Towing the Genie Z-45/25 or the Z-45/25J is
not recommended. If the machine must be towed,
do not exceed 2 mph / 3.2 km/h.
Transport
Transport Instructions
Observe and Obey:
The transport vehicle must be parked on a level
surface.
The transport vehicle must be secured to
prevent rolling while the machine is being
loaded.
Be sure the vehicle capacity, loading surfaces
and chains or straps are sufficient to withstand
machine weight. See the serial plate for the
machine weight.
Be sure the turntable is secured with the
turntable rotation lock before transporting. Be
sure to unlock the turntable for operation.
Securing to Truck or Trailer for
Transit
Always chock the machine wheels in preparation
for transport.
Use the tie points on the drive chassis for
anchoring down to the transport surface.
Use the rotator guard under the platform to secure
the boom from side-to-side movement. Do not use
excessive downward force when securing the boom
section.
Use chains or straps of ample load capacity.
Turn the key switch to the off position and remove
the key before transporting.
Inspect the entire machine for loose or unsecured
items.
Disengage
Position
Engage
Position