Filter
Top Products
Part No. 52421 Genie Z-45/25 & Genie Z-45/25J 19
Operator's ManualFirst Edition · Seventh Printing
Test Drive and Braking
31 Press down the foot switch.
32 Slowly move the drive control handle in the
direction indicated by the blue arrow on the
control panel until the machine begins to move,
then return the handle to the center position.
Result: The machine should move in the
direction that the blue arrow points on the drive
chassis, then come to an abrupt stop.
33 Slowly move the drive control handle in the
direction indicated by the yellow arrow on the
control panel until the machine begins to move,
then return the handle to the center position.
Result: The machine should move in the
direction that the yellow arrow points on the
drive chassis, then come to an abrupt stop.
Note: The brakes must be able to hold the machine
on any slope it is able to climb.
Test the Drive Enable System
34 Move the lift/drive select switch to the lift
position (if equipped).
35 Press down the foot switch and lower the boom
to the stowed position.
36 Rotate the turntable until the
primary boom moves past
one of the non-steer wheels.
Result: The drive enable
indicator light should come
on and remain on while the
boom is anywhere in the
range shown.
37 Move the lift/drive select
switch to the drive position (if equipped).
38 Move the drive control handle off center.
Result: The drive function should not operate.
39 Move and hold the drive enable toggle switch to
either side and slowly move the drive control
handle off center.
Result: The drive function should operate.
Note: When the drive enable system is in use, the
machine may drive in the opposite direction that the
drive and steer control handle is moved.
Use the color-coded direction
arrows on the platform
controls and the drive chassis
to identify the direction of
travel.
FUNCTION TESTS
Blue
Yellow