Filter
Top Products
20 Genie Z-45/25 & Genie Z-45/25J Part No. 52421
Operator's Manual First Edition · Seventh Printing
FUNCTION TESTS
Test Limited Drive Speed
Z-45/25 & Z-45/25J Standard Base Models
ANSI and CSA Z-45/25 & Z-45/25J Narrow
Base Models before serial number 19081
40 Move the lift/drive select switch to the lift
position (if equipped).
41 Press down the foot switch.
42 Raise the primary boom approximately
2 feet / 61 cm.
43 Move the lift/drive select switch to the drive
position (if equipped).
44 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the primary boom raised should not exceed
1 foot / 30 cm per second.
45 Move the lift/drive select switch to the lift
position (if equipped).
46 Lower the primary boom to the stowed position.
47 Raise the secondary boom approximately
2 feet / 61 cm.
48 Move the lift/drive select switch to the drive
position (if equipped).
49 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the secondary boom raised should not
exceed 1 foot / 30 cm per second.
50 Move the lift/drive select switch to the lift
position (if equipped).
51 Lower the secondary boom to the stowed
position.
52 Extend the primary boom approximately
1 foot / 30 cm.
53 Move the lift/drive select switch to the drive
position (if equipped).
54 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the primary boom extended should not
exceed 1 foot / 30 cm per second.
55 Move the lift/drive select switch to the lift
position (if equipped).
56 Retract the boom to the stowed position.
If the drive speed with the primary boom raised, the
secondary boom raised or the primary boom
extended exceeds 1 foot / 30 cm per second,
immediately tag and remove the machine from
service.
Test Limited Drive Speed
CE Z-45/25 & Z-45/25J Narrow Base Models
before serial number 19081
All Z-45/25 & Z-45/25J Narrow Base Models
after serial number 19080
40 Move the lift/drive select switch to the lift
position (if equipped).
41 Press down the foot switch.