Genie Z-45/25 Riding Toy User Manual


 
Part No. 52421 Genie Z-45/25 & Genie Z-45/25J 25
Operator's ManualFirst Edition · Seventh Printing
Auxiliary Controls
Use auxiliary power if the primary power source
(engine) fails.
1 Turn the key switch to ground or platform
control.
2 Pull out the red Emergency Stop button to the
on position.
3 Move the lift/drive select switch to the lift
position when operating the auxiliary controls
from the platform.
4 Press down the foot switch when operating the
auxiliary controls from the platform.
5 Simultaneously hold auxiliary power switch on
and activate the desired function.
The drive and steer functions will not operate with
auxiliary power.
Operation from Ground
1 Turn the key switch to ground control.
2 Pull out the red Emergency Stop button to
the on position.
3 Gasoline/LPG models: Choose fuel by moving
the fuel select switch to the desired position.
4 Start the engine.
Starting the Engine
1 At the ground controls, turn the key switch to
the desired position.
2 Be sure both ground and platform control red
Emergency Stop buttons are pulled out to the
on position.
3 Gasoline/LPG models: Choose fuel by moving
the fuel select switch to the desired position.
4 Move the engine start toggle
switch to either side. If the engine
fails to start or dies, the restart
delay will disable the start switch
for 3 seconds.
If the engine fails to start after 15 seconds of
cranking, determine the cause and repair any
malfunction. Wait 60 seconds before trying to start
again.
All models: In extreme cold conditions, 20°F / -6°C
and below, warm the engine for 5 minutes to
prevent hydraulic system damage.
Gasoline/LPG models: In extreme cold conditions,
20°F / -6°C and below, the machine should be
started on gasoline, then switched to LPG.
Emergency Stop
Push in either ground or platform red Emergency
Stop button to the off position to stop all functions
and turn the engine off.
Repair any function that operates when the red
Emergency Stop button is pushed in.
Selecting and operating the ground controls will
override the platform red Emergency Stop button.
OPERATING INSTRUCTIONS