Filter
Top Products
Part No. 52421 Genie Z-45/25 & Genie Z-45/25J 27
Operator's ManualFirst Edition · Seventh Printing
OPERATING INSTRUCTIONS
Drive Enable
Light on indicates that the boom has moved just
past either non-steer wheel and the drive function
has been interrupted.
To drive, hold the drive enable switch to either side
and slowly move the drive control handle off center.
Be aware that the machine may move in the
opposite direction that the drive and steer controls
are moved.
Always use the color-coded direction arrows on the
platform controls and the drive chassis to identify
the direction the machine will travel.
Generator
To operate the generator, move the generator
toggle switch to the generator position. The engine
will continue to run but no drive or platform
functions will operate.
Plug a power tool into the power to platform GFCI
outlet.
To resume machine functions, move the generator
toggle switch to machine functions position. All
functions will operate.
Drive Speed Select
· Machine on incline symbol: Low range operation
for inclines
· Machine on level surface symbol: High range
operation for maximum drive speed
Engine Idle Select (rpm)
Select the engine idle speed (rpm) using the
symbols on the control panel.
If your control panel
looks like this:
· Rabbit and foot
switch symbol:
foot switch
activated high idle
· Turtle symbol: low idle
· Rabbit symbol: high idle
If your control panel looks like
this:
When the foot switch is not
pressed, the engine will idle at
the lowest rpm.
· Turtle symbol: Foot switch activated low idle
· Rabbit symbol: Foot switch activated high idle