Filter
Top Products
Multiple Errors Received During File System Format
Description You receive multiple errors during a file system format.
Cause Probable causes may be:
• Incorrect SAN IPs are used in the Dell NAS Initial Deployment Utility (IDU).
• Incorrect IQNs used while defining hosts in the MDSM.
• Uneven number of LUNs are mapped to the host group.
• LUN size is below the minimum required size.
• Less than minimum number of required LUNs.
Workaround If incorrect SAN IPs are used while running the NAS IDU:
1. Verify that the MD discovery IP used while running the NAS IDU is on the same
subnet as one of the two SAN IPs configured on your controllers.
2. To verify MD discovery IP, log in to your NAS Manger IP using CLI and run the
following command:system maintenance luns configuration iscsi-
view
This command shows the MD discovery IP.
If the IP is not in the same subnet as the IPs configured for your SAN, change the MD
discovery IP to one of the subnets defined on your controller's SAN A and B.
If incorrect IQNs are used while defining hosts in MDSM, verify that the IQNs
displayed in MDSM match the controller IQNs.
To change the discovery IP in the CLI, run the following command:
system maintenance luns configuration iscsi-set -
iSCSIDiscoveryIPs <IP Address> none none
After the command is complete, refresh the host port identifiers. You can now run the
configuration wizard from the NAS Manager again.
1. Compare if the IQNs displayed in MDSM are the same as displayed under the
Mappings tab in the hosts section in the NAS Manager.
2. If there is a mismatch, correct the IQNs used for the hosts in MDSM and try
formatting the system. The LUNs must be discovered and formatted.
If the issue is due to uneven number of LUNs:
1. If an error is encountered, verify that even number of LUNs are mapped to the
host group. An odd number of LUNs is not supported. LUNs have to grow in pairs
starting from 2 to 16.
2. If uneven LUNs are used, correct the count by adding or removing a LUN.
3. Try to format the system.
If the LUN size is below minimum requirements:
1. Verify that the LUNs are larger than the minimum required size of 125 GB.
2. If the LUNs are less than 125 GB, change LUN size to meet or exceed the
minimum required size.
3. Try to format the system.
If the LUN count is below the minimum requirements:
1. Verify that more than one LUN is mapped to the host group. The minimum
number of LUNs required is 2.
2. If the number of LUNs is less than 2, add LUNs to meet the required minimum
LUN count of 2.
186