Filter
Top Products
NOTE:
• If the NAS controller is still an active member in the FluidFS cluster, you must first detach it.
• Connect a monitor to the NAS controller’s VGA port and connect a keyboard to one of the NAS
controller’s USB ports.
1. Press and release the recessed power button at the back of the NAS controller to shut down the NAS
controller.
NOTE: Power off only the NAS controller on which you are reinstalling the FluidFS software. Do
not power off the remaining NAS controllers. Powering off a NAS controller disconnects client
connections while clients are being transferred to other NAS controllers. Clients will then
automatically reconnect to the FluidFS cluster.
2. Press and release the recessed power button at the back of the NAS controller to turn on the NAS
controller.
3. When you see the F11 = BIOS Boot Manager prompt, press F11.
4. Select the boot device USB Flash Disk.
5. Select Reinstall Dell FluidFS <FluidFS_release_to_install>.
NOTE: Reinstall the NAS controller to FluidFS version 2.0 only if you are redeploying the NAS
controller in a FluidFS version 2.0 cluster.
6. Confirm the action by typing resetmysystem (version 3.0) or resetmysystem -v2 (version 2.0) and
pressing Enter.
7. Once the reinstallation completes, the NAS controller will reboot into standby mode.
8. After reinstalling FluidFS, attach the NAS controller to a FluidFS cluster.
165