Filter
Top Products
Table 4 Feature Information for MPLS LDP Autoconfiguration
Feature Name Releases Feature Information
MPLS LDP Autoconfiguration 12.0(30)S 12.0(32)SY
12.2(28)SB 12.2(33)SRB
12.3(14)T 15.0(1)M
12.2(33)XNE
This feature enables you to
globally configure LDP on every
interface associated with a
specified Interior Gateway
Protocol (IGP) instance.
In Cisco IOS Release 12.0(30)S,
this feature was introduced with
support for OSPF.
In Cisco IOS Release
12.0(32)SY, support for IS-IS
was added.
This feature was integrated into
Cisco IOS Release 12.2(28)SB
with support for OSPF.
This feature was integrated into
Cisco IOS Release 12.2(33)SRB.
This feature was integrated into
Cisco IOS Release 12.3(14)T
with support for OSPF.
In Release 15.0(1)M, support for
IS-IS was added.
This feature was integrated into
Cisco IOS Release 12.2(33)XNE
with support for IS-IS on the
Cisco 10000 series router.
The following commands were
modified: mpls ldp autoconfig,
mpls ldp igp autoconfig, show
isis mpls ldp, and show mpls ldp
discovery.
Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S.
and other countries. To view a list of Cisco trademarks, go to this URL: www.cisco.com/go/trademarks.
Third-party trademarks mentioned are the property of their respective owners. The use of the word partner
does not imply a partnership relationship between Cisco and any other company. (1110R)
Any Internet Protocol (IP) addresses and phone numbers used in this document are not intended to be
actual addresses and phone numbers. Any examples, command display output, network topology diagrams,
and other figures included in the document are shown for illustrative purposes only. Any use of actual IP
addresses or phone numbers in illustrative content is unintentional and coincidental.
MPLS LDP Autoconfiguration
MPLS LDP Configuration Guide, Cisco IOS Release 12.4
64