Filter
Top Products
mpls ldp autoconfig area 3
end
interface POS 1/0
no mpls ldp igp autoconfig
MPLS LDP Autoconfiguration with IS-IS Examples
The following example shows the configuration of the MPLS LDP Autoconfiguration feature on POS0/2
and 0/3 interfaces, which are running IS-IS processes:
configure terminal
interface POS 0/2
ip address 10.0.0.1 255.0.0.1
ip router isis
!
interface POS 0/3
ip address 10.1.1.1 255.0.1.0
ip router isis
exit
mpls ip
mpls label protocol ldp
router isis
mpls ldp autoconfig
Additional References
The following sections provide references related to the MPLS LDP Autoconfiguration feature.
Related Documents
Related Topic
Document Title
MPLS commands Cisco IOS Multiprotocol Label Switching
Command Reference
MPLS LDP MPLS Label Distribution Protocol
The MPLS LDP-IGP Synchronization feature MPLS LDP-IGP Synchronization
The MPLS LDP Session Protection feature MPLS LDP Session Protection
Configuring integrated IS-IS Integrated IS-IS Routing Protocol Overview
Standards
Standard
Title
No new or modified standards are supported by this
feature, and support for existing standards has not
been modified by this feature
--
MPLS LDP Autoconfiguration with IS-IS Examples
Additional References
MPLS LDP Configuration Guide, Cisco IOS Release 12.4
62