Filter
Top Products
Command or Action Purpose
Step 3
interface type number
Example:
Router(config)# interface POS 3/0
Specifies the interface to configure and enters interface
configuration mode.
Step 4
no mpls ldp igp autoconfig
Example:
Router(config-if)# no mpls ldp igp autoconfig
Disables LDP for that interface.
Step 5
end
Example:
Router(config-if)# end
Exits interface configuration mode and returns to privileged EXEC
mode.
Verifying MPLS LDP Autoconfiguration with IS-IS
You can verify that the MPLS LDP Autoconfiguration feature is working correctly with the show isis mpls
ldp command.
SUMMARY STEPS
1.
enable
2.
show isis mpls ldp
DETAILED STEPS
Step 1
enable
Enables privileged EXEC mode.
Step 2
show isis mpls ldp
The output of the following show isis mpls ldp command shows that IS-IS is configured on the interface and that
LDP is enabled:
Example:
Router# show isis mpls ldp
Interface: POS0/2; ISIS tag null enabled
ISIS is UP on interface
AUTOCONFIG Information :
LDP enabled: YES
SYNC Information :
Required: NO
The output shows :
Verifying MPLS LDP Autoconfiguration with IS-IS
How to Configure MPLS LDP Autoconfiguration
MPLS LDP Configuration Guide, Cisco IOS Release 12.4
60