Filter
Top Products
Serial2/0 (ldp): xmit/recv
Enabled: Interface config, IGP config;
Hello interval: 5000 ms; Transport IP addr: 10.11.11.11
LDP Id: 10.10.10.10:0
Src IP addr: 10.0.0.1; Transport IP addr: 10.10.10.10
Hold time: 15 sec; Proposed local/peer: 15/15 sec
Configuring MPLS LDP Autoconfiguration with IS-IS Interfaces
The following steps explain how to configure the MPLS LDP Autoconfiguration feature for interfaces that
are running IS-IS processes.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface type number
4.
ip address prefix mask
5.
ip router isis
6.
exit
7.
mpls ip
8.
mpls label protocol ldp
9.
router isis
10.
mpls ldp autoconfig [level-1 | level-2]
11.
end
DETAILED STEPS
Command or Action
Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Configuring MPLS LDP Autoconfiguration with IS-IS Interfaces
How to Configure MPLS LDP Autoconfiguration
MPLS LDP Configuration Guide, Cisco IOS Release 12.4
57