Filter
Top Products
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
mpls ip
4.
mpls label protocol {ldp | tdp | both}
5.
interface tunnelnumber
6.
tunnel destination ip-address
7.
mpls ip
8.
exit
9.
exit
10.
show mpls ldp discovery [all | vrf vpn-name] [detail
DETAILED STEPS
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
mpls ip
Example:
Router(config)# mpls ip
Configures MPLS hop-by-hop forwarding globally.
•
The mpls ip command is enabled by default; you do not have to
specify this command.
• Globally enabling MPLS forwarding does not enable it on the
router interfaces. You must enable MPLS forwarding on the
interfaces as well as for the router.
Step 4
mpls label protocol {ldp | tdp | both}
Example:
Router(config)# mpls label protocol ldp
Configures the use of LDP on all interfaces. LDP is the default.
• If you set all interfaces globally to LDP, you can override
specific interfaces with either the tdp or both keyword by
specifying the command in interface configuration mode.
MPLS Label Distribution Protocol (LDP)
How to Configure MPLS LDP
MPLS LDP Configuration Guide, Cisco IOS Release 12.4
9